Loading... Please wait...
Our minimum order value is £500 ex vat.
Need Help? 01228 588 960 or 01228 588 956

MATT Photo Slate - Square 14cm x 14cm

MATT Photo Slate - Square 14cm x 14cm with a white polymer coated surface for sublimation printing. These photo slates would be perfect to use as a promotional item or personalised gift. Sold in boxes of 40.
( )

Product Code:
590190M-40


£88.00             40 Slates Per Box = £2.20 each
  -  
  +  








Product Description

Natural MATT 14 x 14cm photo slate with a white polymer coated surface for dye sublimation printing.

Please be aware that the photo slates are made from a natural product which means that they might contain black spots, blemishes, dips and bumps. These are normal and are classed as acceptable by the manufacturers. Please consider this when deciding the image to print onto the photo slate and the positioning of the image.

Sold in boxes of 40

Supplied Boxed and with a rigid plastic stand.

Dimensions: 14cm x 14cm

Clam or 3D press required

Heat Resistant gloves are required to handle this item as it is extremely hot once it has been sublimated.

Clam Pressing Instructions:

Tip: We recommend using a smooth thin silicone matt under the slate to help even out pressure distribution and orientating the slate facedown so that the slate is pressing in to your print/transfer

400 SECONDS 185°C MEDIUM
Further information:

The above pressing information is a guideline only as all heat presses vary from different manufacturers.

Tips and Tricks

Slates are a natural product rather than manufactured so variance between slates is unavoidable, please find a few tips below to help you deal with these.

Slates must be heated through to at least room temp before going in the press to avoid the risk of thermal shock causing cracks.

Pre-press the slates for a short amount of time before adding your print (5-15 seconds) this can help eliminate any residue of moisture held in the porous rock slate as well as reduce the factor of the slate dropping the press temperature when introduced.

It is recommended to press this product face down so the coated area and print are being pressed into the foam press bed on the bottom and it is heated through from the back, this can help even out pressure distribution.

Polyester fabric (which can be found on our website) is the recommended top cover for the slates as this also helps further out pressure distribution.

Slates will be extremely hot and will remain so for quite a long time when they come out of the press, be sure to have your heat-resistant gloves at the ready.

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!